GE JCBP40 Manuel Du Propriétaire page 30

Before you call for service...
Troubleshooting Tips
Problem
Oven racks are
difficult to slide
Excessive smoking
during a clean cycle
Oven door will not
open after a clean
cycle
Oven not clean after
a clean cycle
"LOCK DOOR" flashes
in the display
LOCKED" light is
on when you want
to cook
"F – and a number
or letter" flash
in the display
Display goes blank
Display flashes
Unable to get the
display to show "SF"
Power outage,
clock flashes
30
Possible Causes
The racks were cleaned
in a self-clean cycle.
Excessive soil.
Oven too hot.
Oven controls not properly set. • See the Using the self-cleaning oven section.
Oven was heavily soiled.
The self-clean cycle has been • Close the oven door.
selected but the door is not
closed.
The oven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperature.
You have a function
error code.
If the function code repeats.
A fuse in your home may be
blown or the circuit
breaker tripped.
The clock is turned off from • See the Special features of your oven control section.
showing in the display.
Power failure.
Oven control pads were
not pressed properly.
Power outage or surge.
What To Do
• Apply a small amount of vegetable oil to a paper
towel and wipe the edges of the oven racks with
the paper towel. Do not spray with Pam
lubricant sprays.
• Touch the OFF pad. Open the windows to rid the
room of smoke. Wait until the LOCKED light goes off.
Wipe up the excess soil and reset the clean cycle.
• Allow the oven to cool below locking temperature.
• Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
• Touch the OFF pad. Allow the oven to cool.
• Touch the OFF pad. Put the oven back into operation.
• Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
• Replace the fuse or reset the circuit breaker.
• Reset the clock.
• The BROIL and BAKE pads must be touched
at the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must
reset it by touching the OFF pad, setting the clock
and resetting any cooking function.
® or other