3.6
Using the shaking bath
3.6.1 Bath controls
The bath power mains switch is located are the rear of the unit.
The front panel controls are shown below
Up
Set
Down
3.6.2 Setting the control temperature
Once the control temperature is entered the bath shows a scrolling bar display indicating the
bath is heating. When the bath is with 1°C of the control temperature this will change to
displaying the actual water temperature in the bath.
32136 V3
Page 6
.
.
VWR shaking water bath Instruction Manual
Alarm
indicator
Over
temperature
protection
Shaking
Stop/Start
Shaking
speed
European edition