Belkin G Plus MIMO Manuel De L'utilisateur page 85

Manually Configuring Network Settings
Manually Configuring Network Adapters in Windows 98SE or Me
1.
Right-click on "My Network Neighborhood" and select "Properties"
from the drop-down menu.
2.
Select "TCP/IP Settings" for your installed network adapter. You will
see the following window.
3.
If "Specify and IP address" is selected, your Router will need to be
set up for a static IP connection type. Write the address information
in the table below. You will need to enter this information into the
Router.
4.
Write the IP address and subnet mask from the "IP Address" tab
(3)
.
5.
Click the "Gateway" tab
chart.
6.
Click the "DNS
Configuration" tab
Write the DNS address(es)
in the chart.
7. If not already selected,
select "Obtain IP address
automatically" on the IP
address tab. Click "OK".
Restart the computer. When the computer restarts, your network
adapter(s) are now configured for use with the Router.
(2)
. Write the gateway address down in the
(1)
.
83 83
1
2
3
4
5
6
7
8
9
10