Belkin G Plus MIMO Manuel De L'utilisateur page 83

Manually Configuring Network Settings
4.
Select the "TCP/IP" tab
"Manually" or "Using DHCP". If you do not, check the PPPoE tab
(5)
to make sure that "Connect using PPPoE" is NOT selected. If it
is, you will need to configure your Router for a PPPoE connection
type using your user name and password.
5.
If "Manually" is selected, your Router will need to be set up for a
static IP connection type. Write the address information in the table
below. You will need to enter this information into the Router.
6.
If not already selected, select "Using DHCP" next to "Configure"
(4)
, then click "Apply Now".
Your network settings are now configured for use with the Router.
(3)
. Next to "Configure"
81 81
(4)
, you should see
1
2
3
4
5
6
7
8
9
10