Before First Use - Zanussi ZDT16003FA Notice D'utilisation

If one or more options are set, make sure
that the related indicators are on before
the programme starts.
Multitab option
Activate this option only when you use the
combi detergent tablets.
This option deactivates the flow of rinse aid and
salt. The related indicators are off.
The programme duration can increase.
Activating the multitab function
Activate or deactivate the multitab function
before the start of a programme. You can-
not activate or deactivate this function while a
programme operates.
1. Press the on/off button to activate the appli-
ance. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
2. Press the multitab button, the multitab indi-
cator comes on.
The function stays on until you deactivate
it. Press the multitab button, the multitab
indicator goes off.
If you stop to use the combi detergent
tablets, before you start to use separately
detergent, rinse aid and dishwasher salt,
do these steps:
1. Deactivate the multitab function.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the
rinse aid dispenser are full.
4. Start the shortest programme with a rinsing
phase, without detergent and without
dishes.

Before first use

1. Make sure that the set level of the water
softener agrees with the water hardness in
your area. If not, adjust the water softener.
Contact your local water authority to know
the water hardness in your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
20
5. Adjust the water softener to the water hard-
ness in your area.
6. Adjust the released quantity of rinse aid.
Acoustic signals
The acoustic signals operate in these condi-
tions:
• The programme is completed.
• The level of the water softener is adjusted
electronically.
• The appliance has a malfunction.
Factory setting: on. You can deactivate the
acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the appli-
ance. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
2. Press and hold function buttons (B) and (C)
at the same time until the indicators of func-
tion buttons (A), (B) and (C) flash.
3. Press function button (C),
• The indicators of function buttons (A)
and (B) go off.
• The indicator of function button (C) con-
tinues to flash.
• The display shows the setting of the
acoustic signals.
4. Press function button (C) to change the
setting.
5. Deactivate the appliance to confirm.
4. Open the water tap.
5. Processing residues can stay in the appli-
ance. Start a programme to remove them.
Do not use detergent and do not load the
baskets.
If you use the combi detergent tablets, ac-
tivate the multitab option.
On
Off
www.zanussi.com