Before First Use - Zanussi ZDT16020FA Notice D'utilisation

ADJUSTING THE RINSE AID LEVEL
You can set the released quantity of rinse aid between level 1 (minimum quantity) and level 6 (maximum
quantity).
Level 0 will deactivated and no rinse aid will be released.
Factory setting: level 4.
While the appliance is in user mode:
1. Press
• The indicators
• The indicator
• The display shows the current setting: e.g.
2. Press
3. Press the on/off button to confirm the setting.
ACTIVATING THE ACOUSTIC SIGNAL FOR THE END OF PROGRAMME
By default this acoustic signal is deactivated but it is possible to activate it.
While the appliance is in user mode:
1. Press .
• The indicators
• The indicator
• The display shows the current setting:
– = acoustic signal off.
– = acoustic signal on.
2. Press to change the setting.
3. Press the on/off button to confirm the setting.

BEFORE FIRST USE

1. Make sure that the current level of the water
softener agrees with the hardness of the water
.
, and go off.
continues to flash.
to change the setting.
, and
continues to flash.
= level 4.
go off.
supply. If not, adjust the level of the water
softener.
2. Fill the salt container.
25