Zanussi ZDT16003FA Notice D'utilisation page 23

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. Press the on/off button to activate the appli-
ance. Make sure that the appliance is in set-
ting mode, refer to 'SETTING AND START-
ING A PROGRAMME'.
• If the salt indicator is on, fill the salt con-
tainer.
• If the rinse aid indicator is on, fill the rinse
aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme for the
type of load and the degree of soil.
Using the detergent
1
A
3
Put the detergent or
the tablet in compart-
ment (A).
www.zanussi.com
2
A
B
If the programme has
a prewash phase, put
a small quantity of
detergent in compart-
ment (B).
Setting and starting a programme
Setting mode
The appliance must be in setting mode to ac-
cept some operations.
The appliance is in setting mode when, after
the activation:
• The display shows 2 horizontal status bars.
• The indicators of the programme buttons
come on.
If the control panel shows other conditions,
press and hold function buttons (B) and (C) at
the same time until the appliance is in setting
mode.
Starting a programme without delay start
1. Open the water tap.
2. Press the on/off button to activate the appli-
ance.
3. Make sure that the appliance is in setting
mode.
4. Set the programme. The related programme
number flashes in the display.
5. Close the appliance door. The programme
starts.
• If you open the door, the display shows
the programme duration that decreases
with steps of 1 minute.
Starting a programme with delay start
1. Set the programme.
4
23

Publicité

Table des Matières
loading

Table des Matières