Installation And Aiming - Siemens Milltronics easy aimer 2 Instructions D'utilisation

Installation and Aiming

1. Install the Easy Aimer and transducer assembly by bolting the mounting block
directly to the bin or via a mounting plate.
2. By manipulating the conduit, aim the transducer at the desired point.
3. Tighten the clamping screws to secure the transducer aiming.
clamping plate
(upper socket)
mounting
plate and
hardware
(customer
supplied)
tighten to 20 N-m
(15 ft lb) of torque
tighten to 27 N-m
(20 ft lb) of torque
gasket
(customer supplied,
recommended
thickness 1.5-1.8 mm
(0.06-0.07"))
mounting plate with
welded studs
(customer supplied)
7ML19985HG62
basic installation
sealed installation
Easy Aimer 304 – INSTRUCTION MANUAL Page 15