Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation
The MCS belt scale works with an existing troughed conveyor and a Siemens Milltronics
integrator. As material moves along the conveyor belt and travels over the belt scale, it
exerts a force proportional to the material load through the belt and suspended idler to
the load cells.
The MCS reacts only to the vertical component of the applied force. The resulting
movement in each load cell is sensed by its strain gauges. When the strain gauges are
excited by voltage from the electronic integrator, they produce an electrical signal
proportional to weight, which is then returned to the integrator. The vertical movement of
the load cells is limited by the positive overload stop incorporated into the MCS design.
Installation
The MCS weighbridge components are shipped from the factory as a single unit in a
heavy-duty shipping container. The container is packed to separate each item and to
provide protection during shipment. Each item should be inspected as it is removed from
the container.
IMPORTANT:
MCS belt scale in relation to your conveyor system. See
page 7 for more information.
Notes:
•
Adjust conveyor stringers to be rigid, straight, parallel to, and square with the belt
line in the area of the scale installation.
•
Adjust pulleys to ensure that the conveyor belt tracks straight and centrally from
the head to the tail pulley.
To avoid potential scale installation problems, please compare the site conditions with
the MCS installation drawings available on www.siemens-milltronics.com. If you have
any questions, please contact your Siemens Milltronics representative.
Follow the installation procedure carefully and read the related materials.
Page 4
Before installation, be sure to determine the ideal position of your
MCS Belt Scale – INSTRUCTION MANUAL
Installation Location
on
7ML19985HN61
Publicité
Table des Matières
