Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Procedure
1.
Remove the idler at the chosen location on the conveyor.
2.
Remove the idler mounting brackets and cut the spine as shown.
before
Notes:
•
Cut the idler support as shown to allow clearance when the load is applied.
•
Maximum allowable idler spine for fitting to an MCS is:
Angled spine: 75 mm (3")
Channel spine: 100 mm (4")
Page 12
MCS Belt Scale – INSTRUCTION MANUAL
after
7ML19985HN61
Publicité
Table des Matières
