Gas Burners; Ignition - Dacor DOP36P86DL Série Manuel D'utilisation

Gas burners

LR
CR
LF
RR
CF
RF
Position Purpose
Right Front (RF) Power heating/
22,000 BTU Low simmering
Quick heating/
Right Rear (RR)
16,000 BTU Low simmering
Center Front (CF)
Quick heating
16,000 BTU
Center Rear (CR)
Quick heating
16,000 BTU
Left Front (LF) Power heating/
22,000 BTU Low simmering
Left Rear (LR) Quick heating/
16,000 BTU Low simmering
DOP36P86DLS_DA_DG68-01105E-00_EN+MES+CFR.indb 21
Each burner has a corresponding knob that
enables you to set the flame level from LO
to HI. In addition, each burner has a Lite
setting. Turning a knob to Lite ignites the
corresponding burner. The burner indicators
are located above the corresponding knob
and show which burner the knob controls.
Each burner is designed for specific cooking
purposes.
Food type Characteristics
Boiling food,
Maximum output
tomato sauce
Delicate food that
General/Chocolate,
requires low heat
casseroles, sauces
for a long time
General-purpose
General
cooking
General-purpose
General
cooking
Boiling food,
Maximum output
tomato sauce
Delicate food that
General/Chocolate,
requires low heat
casseroles, sauces
for a long time

Ignition

Make sure all surface burners are properly
installed.
1.
2
2.
1
3.
Manual ignition
You can ignite the burner manually in case of a power failure. Use caution when
doing this.
1. Hold a long gas grill lighter to the surface burner you want to light.
2. Push in and turn the control knob for that burner to the Lite position. Turn on
the grill lighter to ignite the burner.
3. After the burner is lit, turn the control knob to adjust the flame level.
Push in and turn the control knob to the
Lite position. You will hear a "clicking"
sound indicating the electronic ignition
system is working properly.
After the surface burner lights, turn
the control knob to shift it out of the
Lite position and turn off the electronic
ignition system.
Turn the control knob to adjust the
flame level.
English 21
2020-07-06 오후 3:53:34