Belkin F5D7230-4 Manuel De L'utilisateur page 97

Masquer les pouces Voir aussi pour F5D7230-4:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 120
Troubleshooting
2.
Unplug the cable or DSL modem from its power source for three
minutes. After three minutes, plug the modem back into its
power source. This may force the modem to properly recognize
the Router.
3.
Unplug the power to your Router, wait 10 seconds, and then
reconnect the power. This will cause the Router to reattempt
communication with the modem.
If the "WAN" light on the Router is not lit after completing these
steps, please contact Belkin Technical Support.
4.
Try shutting down and restarting your computer.
Problem:
The Easy Install Wizard completed installation, but my web
browser doesn't work.
I am unable to connect to the Internet. The Router's "WAN" light
is on and the "Connected" light is blinking.
Solution:
If you cannot connect to the Internet, the "WAN" light is on, and
the "Connected" light is blinking, the problem may be that your
connection type may not match the ISP's connection.
If you have a "static IP address" connection, your ISP must
assign you the IP address, subnet mask, and gateway address.
Please refer to the section entitled "Alternate Setup Method" for
details on changing this setting.
If you have a "PPPoE" connection, your ISP will assign you a
user name and password and sometimes a service name. Make
sure the Router connection type is configured to PPPoE and the
settings are entered properly. Please refer to the section entitled
"Alternate Setup Method" for details on changing this setting.
You may need to configure your Router to meet the specific
requirements of your ISP. To search our Knowledge Base for
ISP-specific issues, go to: http://web.belkin.com/support and
type in "ISP".
95
95
1
2
3
4
5
6
7
8
9
10

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wireless g plus

Table des Matières