Replacing The Battery In The Remote Control; Synchronising The Powersock Battery Packs And The Remote Control After Loss - therm-ic PowerSock Heat Socken Mode D'emploi

I N S TR U C TI O N S FO R U S E / E N G LI S H
PowerSock
Heat-
rc 1400
level
1 12 - 16 h
2 6.5 - 8.5 h
3
4.0 - 5.5 h
The heating period per charge depends on the
selected heating level, the ambient temperature
and the charging status as well as the age of the
batteries.
R E P LA C I N G TH E B A T TE R Y I N TH E
R E MO TE C O N TR O L
If you wish to exchange the battery, remove the clip
(Fig. 4) and open the remote control (Fig. 5.1).
When replacing the battery (Fig. 5.2), remove the
PowerSock PowerSock
ic 1200
ic 1400
12 - 16 h
10 - 14 h
6.5 - 8.5 h 5.5 - 7.5 h
4.0 - 5.5 h 3.5 - 4.5 h
old battery and ensure correct polarity when
inserting the new battery (type CR 2032).
S Y N C H R O N I S I N G TH E P O W E R S O C K
B A T TE R Y P A CK S A N D TH E R EM O TE
C O N TR O L A FTE R LO S S
If a new PowerSock rc battery pack or remote
control is purchased to replace lost parts, the
sender frequency between the remote control and
the PowerSock rc battery pack must be readjusted.
This is done as follows:
1. Place the two PowerSock rc battery packs next
to each other and keep holding down the "+"
control button (Fig. 1.3) of the two PowerSock rc
battery packs. After approx. 6 seconds, the heat
setting display (Fig. 1.2) will flash three times
and will then continue to be permanently on in
programming mode.
– 26 –