Heat Level - Heating Period - therm-ic PowerSock Heat Socken Mode D'emploi

Note:
Both PowerSock battery packs can be used
independently with different heat levels.
Using the remote control
Changing the heat setting:
 The +/- control buttons (Fig. 2.2) allow you to set
three different heat levels.
 Every time you push the "+" or "-" control button
(Fig. 2.2), the heat level changes.
 The respective heat level is indicated by the
flashing of the heat setting display on the
PowerSock battery pack and the remote control
(Fig. 1.2 and 2.1)
Turning off the heat (standby):
 Press the "-" control button of the remote control
(Fig. 2.2) for a longer period of time (3 seconds)
to turn off the heat.
 The PowerSock battery packs are now in
standby mode.
 The heat setting display on the PowerSock
battery packs (Fig. 1.2) briefly flashes at an
interval of 2.5 seconds.
 Press the "+" or "-" control button again to turn on
the heat again.
STANDBY
  
Note:
If you are using the remote control, both
PowerSock battery packs will be set to the same
heat level.
H E A T LE V E L - H E A T I N G P E R I O D
For your orientation, the following table shows the
max. temperature and the heating period for the
heat levels, which can be set using the control
buttons.
– 25 –