therm-ic PowerSock Heat Socken Mode D'emploi page 21

shaft of the charger (Fig. 3.4). Please check the
illustration on the charger to ensure proper
orientation. The PowerSock battery packs can
be charged in any operating mode. The charging
process will start automatically and the charge
indicator (Fig. 3.2) will light up in red during
charging.
2. Once the PowerSock battery packs are fully
charged, the charging process is automatically
concluded and the LED on the charge indicator
(Fig. 3.2) will switch back to green.
3. Remove both PowerSock battery packs from the
charging shaft.
4. After the PowerSock battery packs have been
charged, they are automatically in POWER OFF
mode.
Important note:
 Recharge the PowerSock battery packs after
each use. This extends the service life of the
batteries and ensures that the device is always
ready for use.
 The battery consists of lithium ion cells and can
be charged in any state. For this reason, the
battery does not need to be fully discharged
before charging.
 When starting the charging process, the
PowerSock battery packs can be in any
operating mode (POWER OFF, STANDBY, IN
USE)
 The full charging capacity of the PowerSock
battery packs can only be conserved if the
PowerSock battery packs are removed from the
charging station after the charging procedure is
complete.
Charging times:
Battery
Charging
time
– 21 –
PowerSock PowerSock
ic 1200
ic / rc 1400
6 - 8 h 5 - 7 h