Festo CLR 0312NH Notice D'utilisation page 22

CLR−...
Remove the packing except for the adhesive labels on the compressed air
S
connections (to prevent dirt).
The packing is intended for recycling (except for: oiled paper which must be
disposed of ).
Observe the ambient conditions at your location.
S
Make sure there is a supply of correctly
S
prepared compressed air (see chapter
Technical specifications").
Once a medium has been selected, keep
S
this unchanged over the complete service
life of the product.
Example:
selected: non−lubricated compressed air,
continue to use: non−lubricated compressed air.
Conversion from lubricated to non−lubricated compressed air:
Observe the wear of the CLR−... .
S
If the service life lubrication is washed out, the CLR−... will wear considerably.
Pressurize your complete system slowly
S
until the operating pressure is reached.
No unexpected movements of the actua
tors will then occur.
For slow start−up pressurization use
safety start−up valve type HEL−... or
HEM−... .
Use the CLR−... in its original state without undertaking any modifications.
S
22
Fig. 6
Fig. 7
Festo CLR−... 0312NH English