Finishing; Log Shipping Bracket; Decorative Panels; Safety Screen / Door Removal And Installation - Napoleon GX70NTE Instructions D'installation Et D'utilisation

32

6.0 FINISHING

EN
IF FINISHING THE FRONT OF THE APPLIANCE, IT MUST BE FINISHED WITH ANY NON-
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
FACING AND/OR FINISHING MATERIAL MUST NEVER OVERHANG INTO THE APPLIANCE OPENING.
6.1

LOG SHIPPING BRACKET

Before installing the logs, you must first remove the log shipping
bracket. Loosen the securing screws indicated.
Lift up to remove.
6.2

DECORATIVE PANELS

This appliance does not include decorative brick panels, however, panels are required.
Panel kits are sold separately. Consult your local authorized dealer / distributor. Refer to the "REPLACEMENT
PARTS" section under "ACCESSORIES".
6.3

SAFETY SCREEN / DOOR REMOVAL AND INSTALLATION

IF EQUIPPED WITH DOOR LATCHES THAT ARE PART OF A SAFETY RELIEF SYSTEM, THEY MUST BE
PROPERLY ENGAGED. DO NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRE OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
A barrier designed to reduce the risk of burns from the hot viewing glass is provided with the
appliance and must be installed.
Before the glass door can be removed, the safety screen must be removed. Lift the safety screen off the four
pins, tilt the top forward and remove from the appliance.
THE DOOR LATCHES ARE PART OF A SAFETY SYSTEM AND MUST BE PROPERLY ENGAGED. DO
Leave a hand on the glass door during entire door removal. The glass door is
secured to the firebox with two spring latches along the top and two along the
bottom. Pull the handles of the latches forward, then lift the latches out from
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
the door frame to release the top of the door. Repeat the same step for the two
OPENINGS, LOUVRE OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
bottom latches. Next, pivot the door forward until the top edge clears the front
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
of the appliance. Carefully grip the sides of the door lifting it off the appliance.
NOTE: These spring latches make up the spring relief system for the
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
appliance. Ensure they open freely and close sealed.
Reverse these steps to re-install the safety screen and door. Ensure safety screen is installed correctly.
W415-1519 / H / 03.22.17
NEVER OBSTRUCT THE FRONT OPENING OF THE APPLIANCE.
COMBUSTIBLE MATERIAL SUCH AS BRICK, MARBLE, GRANITE, ETC.
REMOVED, CRACKED, BROKEN OR SCRATCHED.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
THIS WARNING FOR ELECTRICS ONLY:
NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
WARNING
!
RISK OF FIRE!
SCREWS
WARNING
!
WARNING
!
72.1B
LOG SHIPPING
BRACKET
75.1A
75.1