RedHotDot POWERDUCTION 50 LG Mode D'emploi page 26

POWERDUCTION 50 LG
EN
It is recommended to change the cooling liquid every two years, otherwise you may damage the
Powerduction's lance.
COOLING CIRCUIT AND «FORCED COOLING» MODE
To prevent the cooling liquid's temperature from rising, the cooling fan starts, in any event, when the
liquid's tempera- ture reaches 35°C (95°F). As soon as the temperature goes below that, the cooling fan
switches off.
During long periods of use, the POWERDUCTION has a forced cooling mode. To activate it:
1. Set the main switch (1) to ON. The machine initialises in 2 seconds.
2. Press the activation button (2) as described on page 5. The indicator on button (2) and the lance support
LED (12) both switch on, indicating that the machine is ready to operate.
3. Hold (>3 seconds) the button (10). The « Forced cooling» mode is activated.
The cooling fan then starts automatically. The cooling fan will be audible and the «Fan ON» message will
appear on the display.
To stop the «Forced cooling», press the activation button to stop the heating or hold the button (10) again.
The message «Fan OFF» is displayed.
MAINTENANCE
General recommendations
- It is recommended to change the cooling liquid every two years, otherwise you may damage the
Powerduction's lance.
- It is essential that the maintenance of the product is performed by qualified, authorised staff, that is fully
aware of the recommendations outlined in this manual.
- Never clean, lubricate or perform maintenance on the product when it's being used.
- Before any maintenance work, set the On / Off switch to « 0 » to switch off the machine, .then disconnect
it it from the mains power supply to prevent any electrical shock or other risks resulting from improper
handling.
- Do not wear rings, watches, jewellery, hanging clothes (e.g. ties), torn clothes, scarves, unbuttoned or
unzipped jackets, or anyhting that could get caught during the operation of the machine
- Rather wear clothing specifically designed for the prevention of accidents, such as: n2on-slip shoes, anti-
noise helmets, protective goggles, safety shoes, etc .
- Never use petrol or flammable solvents to clean the product. Prefer the use of water and, if necessary, non
toxic com- mercial solvents.
- After maintenance, always put and secure the metal covers back on, before switching the machine on.
- The ferrite on inductor can be replaced if damaged.
To replace it, you must:
- Remove the protection
- Heat the resin between the ferrite and copper using a heat gun and then remove the ferrite from the copper,
- Clean the copper,
- Glue the new ferrite to the copper using the special resin,
- Cover the ferrite with the protection,
- Wait for the complete hardening of the adhesive resin before using the inductor.
26