RedHotDot POWERDUCTION 50 LG Mode D'emploi page 20

for humans.
- If the ventilation is insufficent, use an approved respiratory unit.
- Read the safety data sheets (MSDS) and the manufacturer's ins- tructions for
adhesvies, flux, metals, consumables, coatings, clea- ning agents, corrosives, and
paint strippers.
- Do not use the heater on parts being degreased or sprayed. The heat might react
with fumes and generate highly toxic gases.
- Work in a confined area only if it's well ventilated, or use an ap- proved
repiratory/filtration unit. Make sure that a qualified per- son is around to watch over
you. The fumes and gases released while heating can replace oxygen or air, causing
accidents or death. Check the quality of the air you're breathing
- Do not overheat metals, such as galvanised steel, covered with lead or cadmium,
unless the coating is removed from the surface before it's heated, that the area is
well ventilated, and if needed,
pieces and all metals containing such elements may generates toxic fumes if
overheated.
Refer to the MSDS for temperature information.
Warning, electrical danger
Warning! Major magnetic field. People wearing active or passive implants must
be informed.
No further protectective steps are required when the machine is used on its own.
Further restrictions and/or protective measures may be necessary in other cases.
After maintenance, the magnetic field levels must be checked be- fore the machine is
used again.
When switched on, never put the inductor near the head or vital organs.
People wearing pacemakers are advised to not come close to the machine. Risk of
disruption of pacemaker operations when close to the machine.
Consult a doctor before getting close to induction heaters.
Risk of metal or adhesive projections
Wear approved protective goggles with lateral protections, or protect the whole face
with a screen.
Wear protective clothes.
Wear gloves.
Do not obstruct the machine's air intake, which facilitates air circu lation. Check the installation chapter
before using the device.
Connection:
This machine must be connected to an earthed socket.
These Class A devices are not intended to be used on a residential site where the
electric current is supplied by the public network, with a low voltage power supply.
There may be potential diffi- culties in ensuring electromagnetic compatibility on
these sites, because of the interferences, as well as radio frequencies.
This hardware is compliant with the IEC 61000-3-12.
POWERDUCTION 50 LG
use an approved filtration/respiratory unit. Foundry
20
EN