Transportation And Storage - Ryobi RY18PCA Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
Secure long hair so that it is above shoulder level to
prevent entanglement in moving parts.
Before use and after any impact, check that there are
no damaged parts on the product. A defective switch
or any part that is damaged or worn should be properly
repaired or replaced by an authorised service centre.
Make sure that the cleaning attachment is properly
installed and securely fastened.
Never operate the product unless all guards, deflectors,
and handles are properly and securely attached.
Consider the environment in which you are working.
Keep the working area free from wires, sticks, stones,
and debris, which if struck by the cutter can become
thrown objects.
BATTERY TOOL USE AND CARE
Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type of
battery pack may create a risk of fire when used with
another battery pack.
Use power tools only with specifically designated
battery packs. Use of any other battery packs may
create a risk of injury and fire.
When the battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys, nails,
screws, or other small metal objects that can make a
connection from one terminal to another. Shorting the
battery terminals together may cause burns or a fire.
Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally occurs,
flush with water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the battery may
cause irritation or burns.
CORDLESS PATIO CLEANER SAFETY WARNINGS
Never allow children, persons with reduced physical,
sensory, or mental capabilities or lack of experience
and knowledge, or people unfamiliar with these
instructions to use the product.
Use the product in daylight or with good artificial light.
Keep proper footing and balance at all times, and be
sure of proper footing on slopes.
Do not walk backwards when using the product. Walk,
never run.
Keep the head attachment below waist level.
Never operate the product with damaged guards or
without the guards in place.
Keep hands and feet away from the cleaning means at
all times, especially when turning on the motor.
To reduce the risk of injury associated with contacting
moving parts, always turn off the product, remove the
battery pack, and allow both to cool down. Make sure
that all moving parts have come to a complete stop:
before servicing
before clearing a blockage
before checking, cleaning, and working on the product
before changing accessories
after striking a foreign object
whenever leaving the product unattended
whenever performing maintenance
whenever the product starts to vibrate abnormally
Wear full eye and hearing protection while using the
product. If working in an area where there is a risk of
falling objects, head protection must be worn.
Hearing protection may restrict the operator's ability
to hear warning sounds. Pay particular attention to
potential hazards around and inside the working area.
Secure long hair so that it is above shoulder level to
prevent entanglement in moving parts.
Always ensure that ventilation openings are kept clear
of debris.
Before use and after any impact, check that there are
no damaged parts on the product. A defective switch or
any part that is damaged should be properly repaired or
replaced by an authorised service centre.
Do not modify the product in any way. This may
increase the risk of injury to yourself or others.
Immediately turn off and remove the battery pack in
the event of accident or breakdown. Do not operate
the product again until it has been fully checked by an
authorised service centre.
Always test the product on the material to be cleaned
prior to starting full operation.
ADDITIONAL BATTERY SAFETY WARNINGS
WARNING
To reduce the risk of fi re, personal injury, and product
damage due to a short circuit, never immerse your
tool, battery pack, or charger in fl uid or allow a fl uid to
fl ow inside them. Corrosive or conductive fl uids, such
as seawater, certain industrial chemicals, and bleach or
bleach-containing products, etc., can cause a short circuit.

TRANSPORTATION AND STORAGE

Turn off the product, remove the battery pack, and allow
the product to cool down before storing or transporting.
Clean all foreign material from the product.
Do not store or transport the product with the battery
pack fitted. Remove the battery pack, and secure it
separately. Store the product in a cool, dry, and well-
ventilated place that is inaccessible to children. Keep
the product away from corrosive agents, such as
garden chemicals and de-icing salts. Do not store the
product outdoors.
Keep the product out of the reach of children.
For transportation in vehicles, secure the product
against movement or falling to prevent injury to persons
or damage to the product.
TRANSPORTING LITHIUM BATTERIES
Transport the battery pack in accordance with local and
national provisions and regulations.
Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
English |
3

Publicité

Table des Matières
loading

Table des Matières