Sanitation; During Class - Laerdal Resusci Anne Modular System Mode D'emploi

Resusci Anne Modular System
We recommend you provide an individual Manikin Face to
each student. This eliminates the need for decontamination
between students.
Using Resusci Manikin Faces
on an individual basis
Each student in the class should install and remove his or
her manikin face.
To remove
1
1 Detach manikin face from retainers at each ear.
2 Lift manikin face off valve coupling.
Using the same Resusci Manikin Face
for all students
If several students are using the same manikin face,
thorough disinfection between students is required.
Laerdal High Level Manikin Disinfectant
Laerdal High Level Manikin Disinfectant (Virkon) Rapid Pack
make disinfection practical. Fill the 100ml bottle with luke
warm water, open sachet and add Virkon to water. Leave for
2 minutes. Push cap firmly onto the bottle until it clicks.
Shake bottle gently to ensure Virkon is fully dissolved.
Spray manikin surface (mouth and nose area) until fully wetted
(6-8 sprays). Do not allow Virkon to run off surfaces. Leave for
30 seconds and wipe thoroughly with a disposable cloth until
dry. Ventilation practice may now continue.
Note: Depending on local policies you may prefer to use
Resusci Manikin Wipes (see below) for cleaning or a freshly
prepared sodium hypochlorite solution, but other procedures
must then be followed.
To use Manikin Wipes
Tear foil packet open.
Take out and unfold wipe.
Rub manikin's mouth and nose vigorously.
Wrap wipe snugly over mouth and nose.
S A N I T A T I O N
D u r i n g c l a s s
2
10
All students can also use one face permanently installed on the
manikin and disinfect the face between each student's use.
To install
1
1 Turn manikin face inside out and push face coupling
into airway valve.
2 Push face coupling into airway connector
until fully seated.
3 Fasten manikin face to retainers at each ear.
Let stay in place for 30 sec.
Dry manikin's face with
a clean paper towel or similar.
Ventilation practice may
now continue.
Manikin Face Shields (optional)
Proper disinfection of manikin's face provides
proper hygienic conditions during training.
However, for aesthetic reasons students may
feel more comfortable having a clean barrier
between own lips and surfaces touched
by another person's lips.
The Manikin Face Shields are designed
to allow inexpensive barrier protection
and to train the use of Resusci Patient
Face Shields made for use in real cases.
To use
Disinfect as instructed above.
Pull a shield out of the roll and tear
off at perforation.
Place shield over manikin's face
as illustrated.
Hold shield in place and airway open,
as illustrated.
Place your lips over the ventilation
opening, pinch the nose,
and ventilate.
Discard shield after each
practice session.
2 3