Lelit Grace Mode D'emploi page 14

C
Switch on the coffee machine
Caution.
Ensure the power supply voltage is the same as that indicated on the
information plate and that the supply system has an adequate circuit breaker.
C.1 Connect one end of the power cord (c) to the socket in the machine and the
other (plug) into the wall socket.
C.2 Turn on the espresso machine by pressing the main on/off switch (2). The dis-
play (12) will show the Lelit logo, the three switches and the gauge will go on for a
short time.
Note.
ONLY for the first time that the machine is switched on, the machine will
start to fill the boiler automatically. During this operation, water will flow from the coffee
distribution group for about 40 seconds and the Lelit logo will flash on the LCC display.
C.3 On the LCC display (12) you'll see the water boiler temperature flashing. This will
grow until the set temperature will be reached.
C.4 Wait until the bar is fully loaded and "Ok" appears on the display. This way the ma-
chine will reach the set temperature.
C.5 After reaching the pre-set temperature, the bar will disappear. The machine will be
ready for use.
D
Checking that the machine is working properly
Coffee
D.1 Insert the filter holder (e) without coffee firmly into the coffee distribution
group (6), so as to align the handle with the padlock symbol on it.
Note.
With a new machine, in order to reach this position, it is advisable to moisten
the edge of the filter with water. After a short period of use, this position will be reached
regularly without excessive effort.
D.2 Press the coffee switch (3) to dispense about half a litre of water. The display
(12) will show the coffee icon and a countdown from the pre-set time for the
coffee dispensing.
D.3 When you've taken about half a litre of water, press the switch (3) to stop dispensing.
This procedure helps filling the hydraulic circuit completely and
Note.
rinsing the circuit itself.
Lelit Espresso - English
EN
13