Gobo Replacement; Procedure; Diagram - Chauvet Professional Maverick MK1 SPOT Manuel D'utilisation

Operation

Gobo Replacement

The gobos in gobo wheel 1 are removable from their gobo holders. Below are the recommended
procedure that must be carefully followed to replace the gobos in gobo wheel 1.
• Make sure to disconnect the product's power cord before replacing a gobo.
• Always replace a gobo with a gobo of the same dimensions.
• When inserting a glass gobo, always make sure that the shiny side of the
gobo (glass base) faces the lamp. This provides a layer of protection against
the high temperature from the lamp.

Procedure

1. Turn the product off and disconnect it from the power outlet.
2. Open the head cover by loosening the 4 Phillips-head ¼-turn screws on the sides of the top
cover.
3. Separate the gobo holder away from the gobo wheel by pushing it toward the front of the moving
head (direction 1 in the diagram). Be careful not to push the gobo out of the gobo holder.
4. Extract the gobo holder by pulling it outward (direction 2 in the diagram).
5. On a flat surface, remove the expansion ring that holds the gobo in place and remove the gobo
from the gobo holder.
6. Insert a new gobo and hold it in place with the expansion ring.
7. Slide the tip of the gobo holder under the pressure plate near the center of the gobo wheel.
8. Push the gobo holder inwards. DO NOT force the gobo holder into the gobo wheel slot. If
correctly installed, the gobo holder should easily slide into the gobo wheel slot.

Diagram

Locate
Maverick MK1 Spot User Manual Rev. 9
Pull Back
Remove
Gobo Holder
Gobo
Retaining
Spring
Page 29 of 191