Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Gas Conversion Procedure - Orifice Replacement
6.
Remove the plastic orifice from the housing. (Figure 2)
7.
Install the new inner and outer gaskets on to the new orifice. (Figure 2)
8.
Install new orifice into housing. (Check the gas type displayed on the orifice: Red Orifice is LPG, Blue Orifice is NG).
9.
Confirm gasket is correctly in place — Groove side of gasket must be facing outwards. Reinstall orifice cover plate using
3 screws to secure it to the gas valve.
10. Turn on the power and gas, then inspect for gas leaks.
11. Proceed to "Parameter Settings" section to complete the conversion.
Figure 2
Grooved side
of Gasket
must be facing
outwards
Cover
Plate
Conversion Manual for Condensing Tankless Water Heater
Outer
Inner
Orifice
Gasket
Gasket
5
Publicité
Table des Matières
