Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Gas Conversion Procedure - Orifice Replacement
Confirm that the inlet gas pressure is between the minimum and maximum pressures allowed for this appliance.
NOTICE
If subsequent conversions are made then a new conversion label must be placed on the water heater to
accurately reflect the gas type.
WARNING
1.
Disconnect the electrical power.
2.
Turn off the gas supply.
3.
Remove 4 screws securing the front panel. Remove front panel.
4.
Locate orifice cover plate on top portion of gas valve. (Figure 1)
5.
Remove 3 screws securing orifice cover plate. (Figure 1)
Figure 1
4
Failure to correctly assemble the components according to these instructions may result in a gas
leak or explosion.
Conversion Manual for Condensing Tankless Water Heaters
Publicité
Table des Matières
