Hansgrohe Axor Starck 10715 1 Série Instructions D'installation page 6


English
Installation
Turn the water off at the main (1).
Cut the plaster shield so that it extends ¹⁄₁₆" - ⅛" from
the finished wall surface (2).
Seal the wall around the plaster
shield with waterproof sealant.
Failure to seal the wall can lead to
possible water damage.
Remove the label.
Remove the flush insert screw using a 5 mm Allen
wrench.
Remove the flush insert and seal.
Insert the function block.
Install and tighten the function block screws using a 4
mm Allen wrench.