Hansgrohe Axor Starck 10715 1 Série Instructions D'installation page 10

1.
!
1.
!
10
English
Axor Massaud only
Install the safety set so that it is oriented as shown in
the diagram. Install the sleeve (1).
Install the escutcheon.
Make sure that the notch is at the bottom of the
2.
escutcheon.
Install the handle adapter and screw (2). Tighten
the screw using a 3 mm Allen wrench.
Install the handle so that the safety stop override
3.
button is at the 12:00 position. Tighten the handle
screw using a 2 mm Allen wrench.
All other models
Install the sleeve so that the indexing mark is at the
12:00 position (1).
Install the escutcheon. Make sure that the notch is at
2.
the bottom of the plate.
Lubricate the valve stem with a small amount of the
enclosed grease.
Install the handle adapter and screw (2). Tighten the
screw using a 3 mm Allen wrench. Lubricate the end
of the adapter with a small amount of white plumber's
3.
grease.
Install the handle so that the safety stop override
button is at the 12:00 position (3). Tighten the handle
screw using a small flat bladed screwdriver.