DURAVIT Darling New 610001 Notice D'utilisation page 53

Problem
A jet of water is not
emerging from the
spray wand.
Heatable seat
The seat is not warm
enough.
The seat temperature
is too high.
Warm air dryer
The dryer tem-
perature is not warm
enough.
Potential cause
The seat sensor is not in
contact with the user.
The water supply hose has
buckled.
The opening of the spray
wand is blocked/soiled.
The seat temperature has
been set to "Off" or "Low".
The seat temperature has
been set to "High".
The dryer temperature has
possibly been set to "Off"
or "Low".
Solution
> Sit down and carry out the
option required.
> Contact your installer to have
this checked.
> Use a small brush to clean
the opening of the spray
wand.
> Set the seat temperature
to "Medium" or "High" at
the remote control
(see chapter 6).
> Set the seat temperature to
"Medium" or "Low" at the re-
mote control (see chapter 6).
> Set the dryer temperature
again.
EN
53