Using The Mattress Tool; Stairways And Landings; Agitator Motor Overload Protection; Thermal Overload Protection - LG Luv400T Manuel Du Propriétaire

Using the Mattress Tool

The mattress tool can be used on your mattress or
bedding to help in the removing of dirt and dust
mites.
This tool vibrates on the mattress to separate the
dust and dirt from intended cleaning area.

Stairways and Landings

Use the Dusting brush or Pet hair turbine tool on
stairs and landings. Make sure that the vacuum
cleaner is placed so that it cannot tip or fall.
See below and page 12 for instructions on selecting
and using attachments.
Agitator Motor Overload
Protection
The agitator has a built-in protection against motor
damage should the agitator jam. If the agitator
slows down or stops, the agitator overload protector
shuts off the agitator motor. The suction motor will
remain on at this time.
To correct problem: Turn off and unplug vacuum
cleaner, remove obstruction and press the reset
button.

Thermal Overload Protection

This vacuum cleaner has a thermal overload
protector which automatically activates to protect
the vacuum cleaner from overheating. If a clog
disturbs the normal flow of air to the motor, the
thermal protector turns the motor off automatically
to allow the motor to cool in order to prevent
possible damage to the vacuum cleaner.
To correct the problem: Turn the vacuum cleaner
off and unplug the power cord. Check for and
remove clogs, if necessary. Also check and clean
any dirty filters.
Wait approximately 30 minutes and plug the
vacuum cleaner in and turn back on to see if the
motor protector has reset. The thermal protector
system will not reset until the vacuum cleaner has
completely cooled down.
OPERATION
15