Cleaning The Foam Pre Filter; Cleaning The Hepa Filter - LG Luv400T Manuel Du Propriétaire

CARE & CLEANING

Cleaning the Foam Pre Filter

CAUTION
A wet filter can cause permanent damage to
the vacuum cleaner. Be sure filters are
completely dry before reinstalling.
For optimal performance, check the filters every
3 months and clean when necessary. Don't close
the dust tank lid without the Foam pre filter.
To Clean the Foam pre filter:
1. Remove the dust tank from the vacuum cleaner.
2. Lift up on the dust tank lid release and open the lid.
3. Lift out the foam pre filter.
4. Separate the foam filter from the filter frame.
5. Shake out any excess dirt or debris and rinse the
foam filter & filter frame with clean water.
And then squeeze out water from foam filter.
6. Dry completely away from sunlight.
18
NEVER operate the vacuum cleaner with wet
filters or components!
If you notice a loss of suction and cleaning the
Foam pre filter does not help, you need to replace
the Foam pre filter. You can purchase additional
foam filters from LG by calling
1-800-243-0000(U.S.A), 1-888-542-2623
(Canada) and asking for parts on page 6.

Cleaning the HEPA Filter

For optimal performance, check the filter every
6 months and clean when necessary.
To Clean the HEPA Filter:
1. Remove the exhaust filter cover.
Exhaust filter
cover
2. Lift out the filter by pressing the hook.
3. Wash the filter cleanly in flowing water.
4. Remove moisture.
5. Dry completely away from sunlight.