Festo CMMO-­ST DION Série Description Et Mode D'emploi page 22

CMMO­ST-...-DION/DIOP
Target group
This documentation is intended exclusively for technicians trained in control and automation techno­
logy, who have experience in installation, commissioning, programming and diagnostics of positioning
systems.
Service
Please consult your regional Festo contact if you have any technical problems.
Documentation
This document only describes the utilisation of the safety function STO – "Safe Torque Off " in accord­
ance with EN 61800-5-2, as implemented in the motor controller CMMO-ST-C5-1-DIOP/DION. The full
description of the motor controller includes the following documents:
Designation
Brief description
1)
CMMO-ST-...
Manual
GDCP-CMMO-ST-EA-SY-...
Help system for the FCT
software
Description
GDCP-CMMO-ST-EA-S1-...
Parameter lists
Special documentation
CMMO-ST_SPUL
1) The documentation is enclosed in printed format.
Tab. 1 Documentation on the CMMO-ST
Additional information about the product:
– Brief documentation (quick start guide) for initial start-up and diagnostics of position­
ing systems in Festo's Optimised Motion Series (OMS) with the web server of the
CMMO-ST
– Overview of accessories (catalogue) è www.festo.com/catalogue
– Operating instructions for configurable actuators and the positioning systems from
Festo (e.g. EPCO) è www.festo.com/sp
– Function elements for Codesys è www.festo.com/sp
– Certificates, declaration of conformity è www.festo.com/sp
22
Contents
Brief equipment and functional description of the motor controller for
initial information.
Equipment and functional description of the motor controller for all
product variants:
– Mounting
– Commissioning via web server/Festo Configuration Tool (FCT)
– Communication via I/O interface
– Technical data
Descriptions of the Festo Configuration Tool (FCT) for commissioning
and parameterisation of:
– Configurable axis/motor combinations
– Positioning systems in Festo's Optimised Motion Series (OMS)
Use of the STO safety function ("Safe Torque Off ").
List with standard settings of the parameter files for positioning
systems in Festo's Optimised Motion Series (OMS).
Requirements for operating the product in the USA and Canada in
accordance with certification by Underwriters Laboratories Inc. (UL).
Festo – GDPC-CMMO­ST-EA-S1-Z6 – 2017-05d – English