Battery Installation - LENCO MC-175SI Mode D'emploi

Remote

BATTERY INSTALLATION

Battery must be inserted correctly to avoid damaging to the remote control. Always remove
the battery when the remote control will not be used for a long period of time, as this may
cause leakage of the battery and subsequently damage the remote.
BATTERY INSTALLATION
Unscrew the battery cover and remove the battery holder. Insert a CR-2025 TYPE battery
(included) with polarities as shown, then push the battery holder back into the remote and screw
the cover back on.
Notes:
If the distance required between the remote control and the appliance decreases, the batteries are
exhausted. In this case replace the batteries with new ones.
1. Power on/off
2. Mute
3. Alarm setting
4. EQ setting
5. Repeat for CD
6. Info
7. Left cursor button
8. Down cursor button
9. Menu
10. Volume +
Volume –
11.
12. Stop
13. Clock setting
14. Sleep
15. Program for CD
16. Snooze
17. CD open/close
18. Up cursor button
19. Enter
20. Right cursor
21. Source
22. Play/Pause
23. Go forward one track
24. Go back one track
25. 0.....9 for selection of the CD track
26. Dimmer
9