Mp3 Disc Section; Program Play - LENCO MC-175SI Mode D'emploi

6. Press the button to hear the previous program track or press the
program track.
Note: After all programmed tracks have been played, the CD player will return to the stop mode.
7. To clear the programmed tracks from memory, press

MP3 DISC SECTION

1. Press the POWER button to turn on the unit.
2. Press the SOURCE button repeatedly to select CD Mode.
3. Close the CD Door and the disc will rotate for a few seconds and then play the 1st track
automatically.
4. Press the and
5. To temporarily stop playback, press the
6. Press the button to stop play.
Note: Because MP3 discs have a large capacity, disc access times are a little longer.
Repeat Playing Function
Single Track Repeat
Press the REPEAT button once to repeat a single track. The display appears as "Repeat one".
Whole Disc Repeat
In Play mode, press the REPEAT button 2 times to repeatedly play all tracks on the disc. The display will
show "Repeat All".
To cancel repeat play, press the REPEAT button repeatedly until the "Repeat off" sign appears.

PROGRAM PLAY

The tracks on the disc can be programmed to play in any order (up to 20 tracks can be programmed).
Note: this can only be done while in Stop mode
1. Press the PROG button while in Stop mode. "P01" "F01" will appear on the display and "T001" will
flash.
2. Press the or
to store in the memory.
3. The first track number is now stored in memory, and the program number changes to "P02", waiting
for your next selection.
4. Repeat Steps 1 – 3 to program additional tracks.
After programming is finished, press the
programmed track. The player stops automatically after all programmed tracks have been played. (Press
the button twice to cancel the programmed tracks memory).
Playing Music via USB
This device has been developed using the latest technical advances in the USB field. However, given the
wide range of USB storage device types that are currently on the market, we unfortunately cannot
guarantee full compatibility with all USB storage devices. For this reason, in rare cases, there may be
problems in playing back files from USB storage devices. This is not due to device malfunction.
1. Press the POWER button to turn on the unit.
2. Press the SOURCE button repeatedly until 'USB' appears on the display.
3. Connect a USB storage device directly into the PLAYER USB port. The display briefly shows the
number of folders and then the total number of tracks. Playback will automatically start.
4. Operation of the control buttons is the same as for MP3 CD playback. Please refer to MP3 DISC
SECTION operations as described previously.
NOTES:
• Always directly connect a USB storage medium to the USB port to prevent any malfunctions.
• The PLAYER USB port is not designed for charging external devices.
• Important: Switch the device to a different operating mode before you remove the USB storage device.
Equalizer Function
With your unit switched on (not in Standby mode):
buttons to choose a track.
button to select the desired tracks in the album, then press the PROG button
button twice.
button; to resume, press the button again.
button, and programmed play begins from the first
16
button to hear the next