KIKKA BOO MEDLEY Mode D'emploi page 4

THANK YOU FOR PURCHASING A PRODUCT PLAYPEN. WE HOPE YOU ARE SATISED WITH ITS USE. PLEASE READ THE INSTRUCTIONS CAREFULLY AND KEEP THIS MANUAL IN A
SAFE PLACE. IF YOU DO THIS, YOU CAN ENDANGER THE HEALTH OF YOUR BABY. PAY SPECIAL ATTENTION TO THE ADVICE ON CLEANING AND CARE PRODUCT. SO YOU CAN
ENJOY IT LONGER.
WARNINGS
• Never leave your baby in the cot unattended.
• Do not use more than one mattress in the cot.
• ONLY USE THE MATTRESS SOLD WITH THIS COT, DO NOT ADD A SECOND MATTRESS ON THIS ONE, SUFFOCATION HAZARDS (FIGURE A).
• The mattress base complies with: EN 716-1.
• Make sure all safety latches are properly locked.
• The assembly parts should always be properly adjusted and should be checked periodically; and if necessary, readjusted.
• Be aware of the risk of open re and other sources of strong heat, such as electric bar res, gas res, etc. in the near vicinity of the cot.
• Do not use the cot if any part is broken, torn or missing and use only spare parts approved by the manufacturer.
• Do not leave anything in the cot or place the cot close to another product, which could provide a foothold or present a danger of suocation or strangulation, e.g. strings,
blinds/curtain cords, etc .
• Do not use the cot when the child is able to get out of it in order to prevent the risk of falls.
• All parts of the cot must be properly positioned so that the baby can never be punctured or snagging your clothing or accessories (paciers chains, shoelaces, ...)
• The cot is ready for use only when the locking mechanisms are in place: this operation must be checked before using the cot.
• Do not use more than one mattress in the cot.
• The lowest position is the safest and that the base should always be used in that positions as soon as the baby is old enough to sit up.
• Only use the mattress sold with this cot, do not add a second mattress on this one, su ocation hazards.
• Place only in this travel cot which oers a rm, even surface.
• Product is suitable for children up to 14 kilograms or 86 cm.
• Product is suitable for children up to 11 kg, or up to 12 months - when used on level 2 (in a two-level set).
BOX CONTENTS: Compact travel cot; Lift (in a two-level set); Padded Base; Carrying bag
1. OPENING OF THE CRADLE AND LOCK TOP FRAME:
- Remove the cradle of the carrying bag and remove the pillow-top mattress that surrounds it.
- Separate each of the corners at the opening of the cradle. The fund should not be Never at ground level, but it must always remain a little high.
- Lift the upper side until it is horizontal. Fit the crossbars until you hear the click ofsecurity. (see Figure 1)
- Check that the frame tubes are rmly coupled trying download them or fold them.
2. LOCK UNDERFRAME:
- To lock the lower structure, press the center of the crib. (see Figure 2)
- Check that the frame tubes are rmly coupled trying download them or fold them. Note: for proper installation of the cradle, you must block part top
of the structure rather than the bottom.
3. INSTALLING THE PADDING BEDSPRING (120 x 60 x2 CM):
- Fold the mattress and place it in the bottom of the cradle, with the printed side looking up. (see Figure 3)
- Adhesive tapes fastening padded mattress should be introduced by the openings in the background fabric and then fasten them to the bottom to
the mattress remains immobilized.
4. ELEVATOR INSTALLATION (in a two-level set):
- The lift must be attached to the cradle with the help of the zipper. (see Figure 4)
- When zipper all around put your hand in the hole to completely close from the bottom.
- Enter the 4 tubes of metal in fabric loops it is at the bottom of the elevator. Attach tubes 2 by 2. (see Figure 5)
- Surround tubes with straps adhesive is in the center controller high.
- The pillow-top mattress should be placed so that it is blocked by the straps at the bottom corners. (see Figure 6).
5. BENDING THE CRADLE:
- Remove the mattress padding. Remove the height adjustment if necessary. (see Figure 7)
- Lift the bottom of the cradle pulling the center. Take this central part from cradle to an intermediate height to the sides of the crib. (see Figure 8)
- To fold each of the upper side pipes, lift slightly and then press the lock button located under the handle (see Figure 9) and fold the crossbar.
- Fold the crib and put the mattress around to keep it folded.
CLEANING AND MAINTENANCE
Maintenance of textile parts:
They can be cleaned with a sponge soaked in warm soapy water.
Fabric composition:
plain fabric: 100% polyester
Mesh fabric: 100% polyester
Pillow-top mattress: 120 x 60 x 2 cm
ENGLISH