Requirements For Product Use - Festo MPPES Notice D'utilisation

MPPES
3

Requirements for product use

Note
General conditions for the correct and safe use of the product, which must be observed
at all times:
• Comply with the specified limit values (e.g. for pressures,
forces, torques, temperatures and electric voltage).
• Compare the specified limit values, e.g. for pressures,
forces, temperatures, with those of your application.
• Ensure that there is a supply of correctly prepared com-
pressed air ( Fig. 2)
• Take into account the prevailing ambient conditions (
Fig. 3 and chap. 11 )
• Also observe the regulations of the trade association, the German Technical Control Board (TÜV),
the VDE and relevant national regulations.
• Too much residual oil content in the compressed air will reduce the service life of the valve.
When using bio-oils (oils that are based on synthetic ester or native ester, e.g. rapeseed oil methyl
ester), the maximum residual oil content of 0.1 mg/m³ should not be exceeded
( ISO 8573-1 [7:4:2]).
• Remove all transport packaging, such as protective wax, foils, caps, cartons (except for plugs in the
pneumatic connections).
The individual materials can be disposed of in recycling containers.
• Pressurise your entire system slowly (e.g. according to Fig. 4)
to avoid any uncontrolled movements.
• Observe the warnings and instructions
– on the product
– in these operating instructions.
• Use the product in its original status, without any unauthorised product modifications.
16
LR-...
LF-...
40 μm
Fig. 2
mbar
C %
Fig. 3
Fig. 4
Festo – MPPES – 1304d English