Railcom: Activating The Cutout In The Lzv200 - Lenz Digital plus LZV200 Manuel D'utilisation

46

To use a 3A transformer, please set a maximum current on the
track of 3A.
9

RailCom: Activating the cutout in the LZV200:

Important Note: RailCom is enabled in the factory default setting!
Use "PoM" ("Programming in operational mode") to activate RailCom.
Before making any settings, familiarise yourself with PoM practices in
combination with the manual control LH100 or LH90. When activating
the RailCom function, the LZV200 must be switched on.
The following procedure activates the blanking interval (cutout) both in
the amplifier component of the LZV200 as well as in the each of the
LV102 amplifiers that are connected to the terminals CDE of the
LZV200.
Proceed as follows:
 Select any locomotive address on the manual control. Don't
worry: If a locomotive with the selected address is placed on the
track during activation, its settings will not be affected because
CV7 can only be read but not changed.
 Change to "PoM"
 Select CV7
 Program the value 50 into CV7. This switches the LZV200 / LV102
into setting mode; the LED of the LZV200 / LV102 shows a double-
flash.
 You have 15 seconds to program the value 93 for activating the
RailCom function into CV7. The LED will shine constantly and
RailCom is activated.
If you want to deactivate RailCom (i.e. disable the blanking interval
(cutout)), proceed as follows:
current (A):
2,5
3
3,5
4
4,5
5
Value in CV7:
5
6
7
8
9
10
Information LZV200