Lenz Digital plus LZV200 Manuel D'utilisation page 40

40
Now switch on the power again (plug in the screw terminal U,V,J,K
again). The lower LED on the front of the LZV200 flashes.
There are 3 LEDs on the update stick which now give you information
about the software status:
red LED
yellow LED
green LED
red yellow
on
on
on on
blinking
flashing
Start the update process by pressing the button on the update stick.
The yellow LED flashes quickly.
Only the next push on the button starts the update. The red, yellow
and green LEDs ("running light") light up alternately during execution.
If the update was successful, the green LED lights up.
If the update failed, the red LED lights up.
If all LEDs are flashing in the same cycle, a defect has occurred at the
central unit. In this case, please contact our service department.
green Version information
Stick and LZV200 version are the
same
on Version stick is newer than LZV200
Version stick ist older than LZV200
Stick is empty
Stick has already been used at
another LZV200
Information LZV200