Skywalker Trampolines SWTC15 Manuel De L'utilisateur page 9

STEP 5
5
Jump Mat (x1)
STEP 6
7
Enclosure Net (x1)
If the enclosure net (7) is already attached to the jump mat (5), go to step
7. (We knew you were an overachiever!) If not, no worries, it's easy to
assemble.
Place the jump mat on the ground. The warning label should be on the top,
and the ID label should be on the back.
Now place the enclosure net (7) on the jump mat (5), and make sure the
first hole and the first V-ring line up. Now insert the first V-ring into the first
hole. Then, insert the remaining V-rings into their corresponding holes. Once
you've finished, the enclosure net should be fully attached to the jump mat.
Important! The first hole is the hole directly to the left of the enclosure door
zipper. The first V-ring is the V-ring directly to the left of the warning label.
1
(7)
First V-ring
Warning label
(5)
9
Warning label on top
First hole
2
4
Model: SWTC15
Part #: 7015
Description:
15 Foot Mat
Made in China
Skywalker Holdings, LLC
PO Box 547, Brigham City, UT, 84302 USA
www.skywalkertrampolines.com
Factory address: Wei Jia Tun Village Ligezhuang
town Jiaozhou city Qingdao China
WARNING
:
Trampoline and enclosures are susceptible to winds, secure your
trampoline and enclosure. Wind damage is not covered in the
warranty of your trampoline.
Winter months can damage your soft materials. Please remove
and properly store during the winter season.
For further information, consult your user manual.
ID label on back
3