Skywalker Trampolines SWTC15 Manuel De L'utilisateur page 10

ASSEMBLY
STEP 7
Place the jump mat (5) on clear ground inside the frame. Make sure the 2 warning decals align with 2 T-joints!
STEP 8
8 16
Springs (x1)
Enclosure door
You may want to use gloves for this step! Before you begin, make sure
each V-ring has been threaded through the holes on the enclosure
net. Make sure the enclosure door is lined up with a T-joint. Using the
spring tool, hook the smaller end of a spring into the V-ring just left of
the enclosure door. Stretch the free end of the spring until it reaches
Spring Tool (x1)
the frame hole just left of the T-joint.
First V-ring
First hole
T-joint Warning label
Enclosure door
Warning label
T-joint
T-joint
10
(16)