Fcc Caution; Industry Canada - Bosch GSB18V-535C Consignes De Fonctionnement/Sécurité

2610045250.qxp_GSB18V-535C 7/7/17 9:41 AM Page 14
military sites or hospitals, are to be observed.
Transmitters have demonstrated an ability to
unintentionally interfere with other devices.
THINK SAFETY
SAFETY IS A COMBINATION OF OPERATOR
COMMON SENSE AND ALERTNESS AT ALL
TIMES WHEN THE TOOL IS BEING USED.

FCC Caution

The manufacturer is not responsible for radio
interference caused by unauthorized modifications
to this equipment. Such modifications could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful
interference, and
2) This device must accept any interference
received, including interference that may cause
undesired operation.
NOTE! This equipment has been tested and
found to comply with the limits for a Class B digital
devices, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
14
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
"Exposure to Radio Frequency (RF) Signals: The
wireless device is a radio transmitter and receiver.
It is designed and manufactured not to exceed the
emission limit for exposure to radio frequency
(RF) energy set by the Ministry of Health
(Canada), Safety Code 6. These limits are part of
comprehensive guidelines and established
permitted levels of RF energy for the general
population.
These guidelines are based on the safety
standards previously set by international standard
bodies. These standards include a substantial
safety margin designed to assure the safety of all
persons, regardless of age and health.
This device and its antenna must not be co-
located or operating in conjunction with any other
antenna or transmitter.
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause undesired
operation of the device.
SAVE THESE INSTRUCTIONS

Industry Canada