Bosch GSB18V-535C Consignes De Fonctionnement/Sécurité page 10

2610045250.qxp_GSB18V-535C 7/7/17 9:41 AM Page 10
BELT CLIP
When the tool is attached to
the belt, position yourself to
avoid entanglement with surrounding objects.
Unexpected entanglement could cause the tool to
fall resulting in injury to the operator or bystanders.
The belt clip accessory will allow you to
conveniently attach your tool to your belt. This
feature will allow you to have both hands free
when climbing a ladder or moving to another work
area.
The belt clip can be attached to either side of the
tool by securing it with a mounting screw. Always
make sure you securely tighten the mounting
screw before use (Fig. 5).
To use clip, turn tool upside down and attach to
your belt.
GCY30-4 CONNECTIVITY MODULE
INSTALLATION
To reduce the risk of injury
read
instructions included with Bosch GCY30-4
connectivity module. Operating instructions for
GCY30-4 connectivity module include important
information not covered in this manual.
Only use Button/coin cell 3V
lithium CR2032 battery. Do
not use any other button/coin cells or other forms
of electrical power supply.
replacement is carried out
properly. There is a risk of explosion.
Keep batteries away from
children. This product contains a lithium
button/coin cell battery. If a new or used lithium
button/coin cell battery is swallowed or enters the
10
FIG. 5
BELT CLIP
the operating
Ensure that battery
Chemical Burn Hazard.
SAVE THESE INSTRUCTIONS
4X BIT TIP HOLDER
Store only bit tips in the on-
tool bit holder. Longer bits
could interfere with proper tool operation and result
in user injury.
The four piece bit tip holder can be used for
convenient on tool storage of your most commonly
used bits.
When mounting bit holder accessory, mount on the
side of the drill opposite the belt clip.
Always make sure you securely tighten the
mounting screw before use. (Fig. 6).
BIT HOLDER
body, it can cause severe internal burns and can
lead to death in as little as 2 hours. If you think a
battery might have been swallowed or placed
inside any part of the body, seek immediate
medical attention.
Always completely secure
the connectivity module
compartment. If the connectivity module
compartment does not close securely, stop using
the product, remove the battery, and keep it away
from children.
When discarding batteries,
insulate the '+' and '–'
terminals with insulating tape. When disposed
of improperly, lithium batteries may short, causing
them to become hot, burst or ignite.
Never
batteries in a fire or expose
to high heat. The batteries may explode.
FIG. 6
dispose of the