Bosch GSB18V-535C Consignes De Fonctionnement/Sécurité page 11

2610045250.qxp_GSB18V-535C 7/7/17 9:41 AM Page 11
If GCY30-4 connectivity module is not purchased
with the tool, or if the replacement of the module
or the battery becomes necessary, please follow
this procedure (See Fig. 7):
- Using a flat screwdriver or a coin, remove the
cover 1 from the side of the handle, by turning
it 1/4 turn counter-clockwise.
- If the tool is already equipped with the
connectivity module, remove the battery 2, but
do not remove the connectivity module 3.
- If the connectivity module is installed for the
first time, remove the plastic placeholder 4
from the connectivity module compartment,
and place the connectivity module 3 in the
compartment observing correct orientation.
Note: Store the placeholder 4 in a safe place.
Reinsert the placeholder again if the
communications module is removed.
- Next place new battery 2 on the top of the
connectivity module with the "+" polarity facing
up.
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger. The
speed can be adjusted from the minimum to
maximum nameplate RPM by the pressure you
apply to the trigger. Apply more pressure to
increase the speed and release pressure to
decrease speed (Fig. 1).
FORWARD/REVERSING
LEVER & TRIGGER LOCK
After tool use, lock trigger in
"OFF" position to help prevent
accidental starts and accidental discharge.
- Place the cover 1 over the battery and turn it
¼-turn clockwise to lock using a flat
screwdriver or a coin.
Operating Instructions
Your tool is equipped with a forward/
reversing lever and trigger lock located above the
trigger (Fig. 8). This lever was designed for
changing rotation of the bit, and for locking the
trigger in an "OFF" position.
For forward rotation, (with chuck pointed away
from you) move the lever to the far left (Fig. 8).
For reverse rotation move the lever to the far
right (Fig. 9). To activate trigger lock move lever
to the center off position.
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to the
tool.
FIG. 8
SAVE THESE INSTRUCTIONS
FIG. 7
1
2
3
4
Do not change direction of
rotation until the tool
FIG. 9
11