Optional Rock Placement; Glowing Embers; Logo Placement; Battery Installation - Napoleon IR3N-1 Instructions D'utilisation

4.4

OPTIONAL ROCK PLACEMENT

REAL ROCKS MUST NOT BE USED IN THIS APPLIANCE. HEAT WILL CAUSE THEM TO EXPLODE
Before beginning with the installation, remove the door and all burner media from the appliance including logs
and charcoal strips. Retain the glowing embers.
A. Sit the two rock clusters on top
of the rear log support. Ensure the
clusters are sitting flat.
D. Reinstall the glowing embers over the burner.
E. Reinstall the door.
4.5

GLOWING EMBERS

Tear the embers into pieces and place along the front row of ports covering all of the burner area in front of
the small logs. Care should be taken to shred the embers into thin, small irregular pieces as only the exposed
edges of the fibre hairs will glow. The ember material will only glow when exposed to direct flame;
however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PHAZER
logs glow when exposed to direct flame. Use only certified "glowing embers" and PHAZER
from your authorized dealer / distributor.
4.6

LOGO PLACEMENT

Remove the backing of the logo supplied and place on the glass viewing door,
as indicated.
4.7

BATTERY INSTALLATION

4 AA batteries must be installed in to the (DC battery pack) before operation is possible. The battery pack
is located in the bottom right corner of the appliance. The door may have to be removed to access, refer to
"DOOR REMOVAL AND INSTALLATION" section. (Refer to "INSTALLATION OVERVIEW" for battery location).
WARNING
!
B. Place the large notched rocks
along the step behind the front
burner as desired.
C. Place the remaining rocks around
the burner as desired making sure
not to cover any burner ports (there
are no set locations).
TM
logs available
½"
(12.7mm)
LOGO
97.1A
W415-1198 / 05.24.13
13
EN
TM
½"
(12.7mm)