Optional Rock Placement - Napoleon High Definition Série Manuel D'installation Et D'opération

finishing
EN
9.9

optional rock placement

WARNING
!
• Real rocks must not be used in this appliance. Heat will cause them to explode.
Before beginning with the installation, remove the door and all burner media from the unit. eg. logs, charcoal
etc. Retain the glowing embers.
Remove the grate by removing the 2 screws that secure it. NOTE: All screws must be re-installed to
A.
maintain a firebox seal.
Remove the 2 screws from the firebox base (as shown). Install the rock support using the 2 screws.
B.
NOTE: The protective plastic coating must be removed prior to operating the appliance.
Sit the two rock clusters on top of the rear log support. Ensure the clusters are sitting flat.
C.
Place the large notched rocks along the inside and outside edges of the rock support as desired.
D.
Place the remaining refractory rocks around the burner as desired, making sure not to cover any
E.
burner ports. (There are no set locations)
Re-install the glowing embers over the front burner ports. Refer to your installation instructions if
F.
necessary. Empty enough sand onto the firebox base to cover all the screw heads. Spread the sand
evenly, making sure not to block the air vents.
Re-install the door.
G.
1
3
5
34
W415-1596 / B / 10.12.18
2 LOG SUPPORT
ROCK SUPPORT
ROCK SUPPORT
4
FRONT BURNER
6
PORTS
AIR VENTS