Installation And Adjustment; Tools - Vermeiren V200 Mode D'emploi

EN
5. A steeper (greater) angle within the preferred zone is desirable.
6. Adjust the belt tightly according to the instructions of the strap-system manufacturer,
consistent with the user's comfort.
7. Ensure that the restraint belt connects in a straight line to the anchor point in the
vehicle and that no bends in the belt are visible, for instance at the axle of the rear
wheel.
8. Install the arm rests, if desired. make sure that belts are not twisted or held away
from the body by wheelchair components such as arm rests or wheels.
3

Installation and adjustment

The instructions in this chapter are for the specialist dealer.
The Vermeiren V200 has been designed to be adjust with a minimum of replacements parts.
There is no need for extra stock of spare parts.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility.
A list of Vermeiren facilities can be found on the last page.
L
WARNING:
manual.
L
WARNING:
wheelchair (tilt back or sideways).
3.1

Tools

To set up the wheelchair the following tools are needed.
Wrench set n° 7 to n° 22
Allen keyset n° 3 to n° 8
Screwdriver n° 4 to n° 5
Screwdriver Phillips head
Risk of unsafe settings - Use only the settings described in this
Variation of allowed adjustments can still change the stability of your
Page 18
V200
2010-11