Water Softening System / Special Salt; Water Hardness Table; Adjusting The Water Softening System - Bosch SHX89PW75N Notice D'utilisation

Setting
Greeting
Factory setting
* depending on the features of your dishwasher
+
Water softening
system / special salt
T o ensure good rinsing results, the
W a t e r s o f t e n i n g s y s t e m / s p e c i a l s a l t
dishwasher requires soft water, i.e.
water which is low in lime, otherwise
limescale will be deposited on the
utensils and interior container. Tap
water above 7° dH (1.2 mmol/l)
must be softened. The water
is softened with special salt
(regeneration salt) in the water
softening system of the dishwasher.
The setting and therefore the
required amount of salt depends on
the degree of hardness of your tap
water (see following water hardness
table).

Water hardness table

Factory setting
On
Reset
Water softening system / special salt en-us
Infotext
by pressing Info button
When switching on the appliance, the brand logo can
be deselected.
Resetting to the factory setting.
Adjusting the water
softening system
The amount of salt dispensed can be
set from 0 to 62°E. Salt is not
required at the set value 0-8.
Set the softening system as follows:
Ask your local water utility
1.
company for the water hardness
value of your tap water or use test
strip.
Required setting can be found in
2.
the water hardness table.
Open the door.
3.
Switch on On/Off switch (.
4.
Press Info button 8 for
5.
3 seconds until the following text
is indicated on the display window
at the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
Keep pressing button > )* until
6.
the water hardness is indicated
on the display window at the top
@.
Make the selection with setting
7.
buttons + - X.
Press and hold the Info button
8.
8 for 3 seconds.
The chosen setting has now been
stored.
15