Water Softening System - Bosch SHE89PW55N Notice D'utilisation

en-us Water softening system / special salt
+
Water softening
system / special salt
To ensure good rinsing results, the
s a l t s y s t e m / s p e c i a l W a t e r s o f t e n i n g
dishwasher requires soft water, i.e.
water which is low in lime, otherwise
limescale will be deposited on the
utensils and interior container. Tap
water above 7° dH (1.2 mmol/l)
must be softened. The water
is softened with special salt
(regeneration salt) in the water
softening system of the dishwasher.
The setting and therefore the
required amount of salt depends on
the degree of hardness of your tap
water (see following water hardness
table).
Adjusting the water softener settings
Using the test strip included with
your dishwasher
(Purchased test strips may have a
different scale)
14
Instructions for use of
included "Water Hardness
Test Strip"
Only use salt designed for automatic
dishwashers. Never use household
water softener salt or table salt.
Follow the instructions below for the
included test strip. (If purchasing a
different test strip, follow
manufacturers instructions).
Run the water at the kitchen sink
1.
for 5 minutes.
Dip the end of the test strip with
2.
the colored squares into the tap
water for 1 second and shake off
excess water.
After one minute, compare the
3.
test strip to the chart below and
determine the Dishwasher Water
Softener setting.
Adjust the dishwasher Water
4.
Softener setting.
If required, add salt to the
5.
dishwasher salt chamber as
shown. ~ "Using special
dishwasher salt" on page 15
Water Add salt to
softener salt
setting dispenser
No
•:‹‹
Yes
•:‹‚
Yes
•:‹ƒ
Yes
•:‹„
Yes
•:‹...
Yes
•:‹†
Yes
•:‹‡
Yes
•:‹ˆ
Water hardness onversion chart
(only necessary if you purchase a
different test strip)
ppm
0 116 0
117 152 7
153 188 9
189 223 11
224 294 14
295 383 18
384 544 23
545 890 32
gpg/°dH
6
8
10
13
17
22
31
52