Coway BA16-CR/CE Mode D'emploi page 26

TROUBLESHOOTING
Problem
Water continues Water will flow out from between the nozzle after cleansing, this is not a malfunction,
•
that is how the nozzle self-cleansing normally functions.
being discharged
even after the
The water droplets from due to condensation created by the heating or the water, this
•
is not a malfunction.
bidet is shut off.
After plugging the
product the nozzle
Have more than 20 seconds elapsed
•
since the power plug was plugged in?
does not spray out
water very long.
Are you sitting out of range of the seat
•
sensor?
The bidet does
not work when
any of the control
Is the Seat Sensor Lock Mode set to on?
•
panel buttons are
pressed.
Are the batteries in the remote control
•
old?
When bidet eco mode is set, you may feel that the seat is relatively cold when taking a
seat. If bidet eco mode is cancelled, the last set temperature is maintained.
Tips
For cancelling bidet eco mode, see page 13.
Check
•
•
•
•
Possible Solutions
Water flows out of the nozzle for 20
seconds until the water temperature is
adjusted.
When the bidet seat is up or the seat
sensor does not sense someone's
presence, the control panel buttons will
not work.
Sit down properly on the bidet.
When the seat sensor lock mode is 'on'
and if you sit down on the bidet seat, the
control buttons will not work. Set the seat
sensor lock mode to 'off' .
Put new batteries in the remote control.