Installation; Remove Existing Toilet Seat; Install The Product - Coway BA16-CR/CE Mode D'emploi

INSTALLATION

Remove existing toilet seat

1. Remove the mounting bolts to detach the existing toilet seat and seat cover.
▶ Keep the removed toilet seat in a dark place to protect it from damage by direct sunlight.
Tips

Install the product

▶ Do not splash the water directly onto the product.
▶ A small amount of water used for the shipping inspection at the factory may remain in the
Tips
MF filter of the product, this is not a defect.
Be sure to connect the product to a cold tap water pipe. If the product is connected to a hot water
pipe, the filter and hose of the product may be damaged.
Caution
1. Close the tap water supply valve. Then unscrew and remove the existing toilet tank
hose.
2. Connect the T-shaped connector to the tap water supply valve along with the
rubber washer.
- Connect the removed toilet tank hose to the T-shaped connector.
- Connect the bidet hose to the T-shaped connector firmly.
3. Fix the MF filter onto filter fixing stopper shown as image.
- Tighten the filter. If not, the bidet may not operate properly.
2
1
2
1