Coway BA16-CR/CE Mode D'emploi page 21

INSTALLATION
Install the product
4. Place the installation plate onto the toilet. Then position the adjustable bracket
with its flat side facing downward. Insert the mounting bolts, rubber cone washers,
mounting washers, and barrel nuts into the installation plate and the adjustable
brackets. Then hand-tighten the nuts lightly.
5. Hold the bidet with both hands and push it backwards until it "clicks" into place.
If the bidet is loose, retighten the nuts.
6. Connect the filter at the back of the bidet. Fix it with filter clip.
Check whether the filter clip is in place. If not, the filter fixing stopper may release
from the product when you open the main water supply valve. In this case, the tap
water may flow out and cause damage.
Once the filter clip is attached to the product, you cannot detach it from the product.
Call the service center regarding this.
7. Connect the bidet hose to filter fixing stopper and T-shaped connector firmly.
Make the bidet hose short as possible. If it is too long, the noise may occur from it.
8. Open the main water supply valve and adapter valve.
9. Connect the poser cord to electrical outlet.
Use only a grounded electrical outlet. In the event of an electrical short circuit, using a
grounded outlet reduces the risk of electric shocks.
Make sure to use a dedicated electrical outlet with grounding terminals.
If required, use an extension cord with grounding terminals for 250 V~, 10 A or higher.
▶
19
20